Microwave Antenna Taconic PCB Double Layer , High Frequency Board
For RF Wireless audio
|Origin:China||Special: Taconic material|
TACONIC company is the world's largest production of PTFE CCL
manufacturer, with a glass woven cloth coated with PTFE patent, is
the PTFE microwave CCL industry, one of the technology leader, and
its microwave CCL's dielectric constant To 2.17-10.0, occupying the
global antenna sheet market share of more than 80%.
TACONIC high-performance insulation materials for the microwave,
radio frequency (RF) and high-speed digital signal processing
market PTFE / woven glass fiber woven sheet. This material can be
used in LNAs, LNBs, PCS / PCN antenna systems, Global Positioning
System (GPS) and UMTS antenna systems, as well as power amplifiers,
passive components, collision avoidance radar systems, aeronautical
telemetry and phase control Array radar system.
PCB Audio Amplifier RF Transceiver Taconic High Frequency PCB
Double Layer 1oz Electronic Circuit TACONIC high-performance
insulating material for microwave, radio frequency (RF) and
high-speed digital signal processing (DSP) market with PTFE/type
woven glass fiber fabric sheet.This material can be applied to LNAs
LNBs, PCS/PCN antenna system, global positioning system (GPS) and
UMTS antenna system,And the power amplifier, passive components,
collision avoidance radar system, aviation help guide remote
control technology and system of the phased array radar.
Taconic materials are UL 94V-0 rated for active devices and high
power RF designs.
High Speed Design Frequency PCB Board Special high electromagnetic frequency circuit boards, in general,
can be defined as the frequency of the high frequency of 1GHz. Its
physical properties, precision, technical parameters required is
very high, commonly used in automotive anti-collision systems,
satellite systems, radio systems, etc.
The basic characteristics of a high frequency board material
requirements are the following:
(1) dielectric constant (Dk) must be small and very stable, usually
the smaller the better signal transfer rate and the dielectric
constant of the material
Inversely proportional to the square root of high dielectric
constant is likely to cause the signal propagation delay.
(2) the dielectric loss (Df) must be small, mainly affect the
quality, the smaller the dielectric loss signal transmission of the
signal loss is smaller.
(3) as far as possible consistent with the coefficient of thermal
expansion of the copper foil, copper foil separated because of
inconsistency will cause changes in the hot and cold.
(4) to low water absorption, high water absorption will affect the
dielectric constant and dielectric loss when damp.
(5) Other heat resistance, chemical resistance, impact strength,
peel strength, etc. must also be good.
- Cellular Base Station Antennas and Power Amplifiers
- Microwave point to point (P2P) links
- Automotive Radar and Sensors
- low dielectric loss
- RF Identification (RFID) Tags
- The stability of the dielectric constant
- An extremely low water imbibition
- LNB’s for Direct Broadcast Satellites